Place vinyl design flat with translucent backing down and thick paper up.
Peel thick paper backing off at a 45 degree angle.
Vinyl image should stick to translucent sticky paper - showing reverse image with sticky side of vinyl exposed.
If vinyl image tries to adhere to thick top paper, let paper back down over letter, rub from top thick paper with credit card edge firmly. Then try and peel again with sharp bending when vinyl appears.
Once all of thick paper is off, your image should be in "reverse" with sticky side exposed.
Position vinyl over area to the placed and carefully lower onto position -- using this method you only have ONE chance, so be careful.
An alternative method is to use scotch tape to position image on one side only, then fold image over and remove thick paper, then fold flat into position. You can use remaining translucent "transfer paper" from previous vinyl images instead of scotch tape.
Once image is adhered, remove translucent "transfer paper" by peeling at 445 degree angle.
Smooth out any air bubbles with a credit card edge. You can use a pin to puncture bubbles.
